04/24/2024
Marc starts off by writing the G-Code that sets our machine in a safe working state before moving on to the drilling section. When drilling…
Watch Video
04/03/2024
Marc leads us through the crucial facing sequence, following the parting off process. Marc demonstrates the efficient reuse of tools from…
Watch Video
03/27/2024
Using constant cutting speed, a G50 speed clamp must be used so the spindle does not reach dangerous speeds as the tool approaches…
Watch Video
03/06/2024
Marc from GCode-Tutor continues this series where he programs a complete part using G-Code on a CNC lathe. This time, he talks about…
Watch Video
02/21/2024
Marc from G-CodeTutor is back with another essential tutorial in his G-Code programming series. This time, he’s tackling center drilling to…
Watch Video
01/31/2024
This time, it’s about screw threads. There are a few ways to approach thread cutting on a CNC lathe by using…
Watch Video
01/17/2024
In the 5th video in this series, Marc Cronin, aka G-Code Tutor manually programs a grooving cycle using…
Watch Video
01/08/2024
Writing a finishing sequence on a lathe using G-Code is quick and easy if we utilize a subroutine when programming the…
Watch Video
01/08/2024
As we continue in this CNC lathe programming series, this time Marc from G Code Tutor shows us how he writes roughing cycles using…
Watch Video
12/15/2023
In this video, Marc from G-Code Tutor looks at the different types of information that can be put in the header section to help make our lives easier…
Watch Video
11/23/2023
This video is all about planning how we are going to make the part. With a solid plan in place, it is much easier and quicker to…
Watch Video
07/05/2023
In this video, Marc from G Code Tutor gives us a refresher lesson on machine shop math. Today we look at the…
Watch Video
06/27/2023
In a machine shop, one of the initial skills we acquire is the ability to read the vernier scale. Nowadays, machine shops are equipped with…
Watch Video
04/28/2023
In the final part of the bush programming series, Marc from G-Code Tutor looks at ways we…
View Article
04/19/2023
In the next part of our programming a bush series, Marc from G-Code Tutor talks us through writing a full…
Watch Video
03/31/2023
Marc from has shown us one way we program roughing turning, finish turning using a subroutine…
Watch video
03/15/2023
Depending on which country you work in, you may have been trained to only use either imperial or metric units when…
Watch Video
02/22/2023
In this video, Marc from GCodeTutor continues writing a program for a bush using G-Code on a CNC lathe…
Watch Video